Electron Microscopy Studio · Reference
Image
Applies to Electron Microscopy Studio 2.1 and later
Image shows a TEM or SEM image with its calibration, and measures on it: distances, angles, line profiles and particles. This page lists every control of the part, which is in the Imaging workspace.
Calibration
| Row | What it says |
|---|---|
| Horizontal (x), Vertical (y) | The size of a pixel along each axis, with its unit |
| Source | Where the calibration comes from |
| The inspector says | What it means |
|---|---|
| "Not calibrated: the scale bar counts pixels." | The file carries no pixel size. Distances are in pixels. |
| "Pixels are not square: the scale bar uses x, and the image is drawn one pixel per pixel." | The two axes differ. Read distances along y with care. |
Display
| Control | What it does |
|---|---|
| Colormap | The colours the values are drawn in |
| The histogram | The values of the image, with the contrast window that sets black and white |
| Gamma | Bends the grey scale between black and white, from 0.2 to 5 |
| Log | Draws log₁₀(1 + I). For a picture that spans decades, such as a diffraction pattern. |
| Show Scale Bar | Draws the scale bar on the image |
The display changes the picture only. Every measurement uses the values of the file.
Measure
| Tool | What it does |
|---|---|
| Pan | Moves the view |
| Distance | Drag between two points: the length |
| Angle | Three points: the angle between the two legs |
| Profile | Drag a line: the values along it. Width sets how many pixels wide the line is; Export Profile… saves the profile as CSV. |
The marks are listed in the inspector. Remove deletes one, Remove All all of them. Every mark is also a row in Results.
Particles
Particles finds objects by a threshold and measures each one.
| Control | Choices | What it does |
|---|---|---|
| Objects | Bright, Dark | Whether the objects are brighter or darker than the background |
| Threshold | Manual, Otsu | A level you set, or Otsu's method |
| Level | With a manual threshold: the level | |
| Smoothing σ | pixels | Smooths the image with a Gaussian before the threshold |
| Connectivity | Which neighbours of a pixel belong to the same object | |
| Minimum area | Objects smaller than this are left out | |
| Tint mask | off, on | Tints the pixels on the object side of the threshold while you edit the settings |
| Region | Draw Region, Whole Image | Drag a rectangle: only its pixels are analysed, and an object cut by its border is an edge object |
| Show Objects, Hide | Finds the objects and draws them, or hides them | |
| Counted only | off, on | The table lists only the objects that are counted |
When the image is not calibrated, or its pixels are not square, the sizes are in pixels. After you change a setting the inspector reads "The settings changed since these objects were found: Show Objects again."
Stack
For a file with several frames.
| Control | What it does |
|---|---|
| Frame | The frame on screen and how many there are |
| Previous, Next | Step through the frames |
| Same contrast for every frame | Pins the contrast window at the range of this frame, so a change of brightness between frames shows |
Info
The Info tab lists the file, the object in it, the size in pixels, the voltage, both axes and the range of the values. Acquisition holds the microscope settings the file records, and Lineage the record of the steps saved with the image.